Embedded Led Light Strip Installation Method

- Jan 10, 2019-

1. When the LED light strip is a roll, please do not illuminate the light strip.

2. Only the scissors mark can be printed on the lamp body, otherwise it will cause a unit to be off.

3. When installing, please bend the lamp to one side to expose 2-3MM copper wire, and cut it with a cutting pliers. Do not leave burrs to avoid short circuit.

4. Do not pass the power supply during the installation or assembly of the lamp strip. Only the connection, the installation and the correct condition can be connected to the power supply.

5, install the LED light strip under cold temperature, you can power on for a few minutes, make the light body soft, easy to bend, and then power off installation.

6. During installation and use, do not hit the lamp with heavy objects and shake the vibration.

7. The end of the lamp tube must be glued with glue before the tail plug is used.

8. Only two lamps with the same specifications and the same voltage can be connected in series. The total length of the serial connection cannot exceed the length of the power supply.

9, each interface must be firm, no short-circuit hidden dangers, outdoor installation, each interface must be sealed with glass glue or other appropriate methods to ensure that the water at each interface.

10, can not be installed in water, flammable, explosive environment, must ensure that the use of the environment is well ventilated.